Step flashing for chimneys.
Install flashing on porch roof.
The flashing on the wall should be flush against it and the porch roof portion should be on top of the shingles.
How to install step flashing with a wall corner step three.
Install the flashing place the flashing between the joint of the house and the roof.
Then set the piece down.
Cut an angle with tin snips on one side of the flashing piece from an end.
Flash the corner first if applicable.
Measure the length of the porch roof joint to determine how much flashing you will need.
Flashing is generally installed at any joints or edges in the roof where water could otherwise work its way in.
Hammer one nail to the.
Now notch the first step flashing so that it.
Bend it back so that it overlaps the corner flashing.
Put on a pair of leather palm gloves to avoid injuries from the sharp edges of the metal flashing.
Nail the flashing securely in place using roofing nails.
If you already have faulty flashing installed you.
Typically flashing is installed using roofing nails and roofing cement.
Nail it in place with two nails one.
Ensure it sits flat and extends at least 8 inches above the shingles.
Installing your roof flashing is going to be slightly different depending on the specific type that you re installing.
Prepare the area where you will install the roof flashing.
How to install porch roof flashing step 1.
Once the shingles have been installed lay the base flashing around the base of the chimney approximately 4 past each end.
