Is there a way to adjust the tension on the end of the awning.
How to tighten awning over slide out.
However perhaps someone here knows how to tighten the slide out awning.
The awning over my slideout is sagging on one end but the other end is tight as both ends should be.
Roller should now be free of mounting hardware.
The roller has a spring in it.
In order to get the awning up and stable the tension needs to be adjusted to get the fabric taut.
Here is brad taylor showing how to adjust an awning fabric.
Make sure it will not fall out.
Dear jim well it depends on the size and make of your slide topper.
The last step is to reinstall the rv awning.
Since you do not tell me who manufactured your slideout topper awnings it will be very hard for me to tell you how to adjust the tension on them.
Only rotate the legs one or two turns at a time and don t do more than 4 or 5 total.
Usually takes 2 people.
Just like that your awning is back in action.
How do you tighten up slideout awnings that are sagging.
Adjusting slide topper awnings is fairly simple.
How to replace spring on awning slideout in rv adjust slide out cover how to tighten loose motorhome slideout covers tightening the spring on a slide out awning slide out kover ii how to adjust spring slide awning toppers tension adjustment how to tighten a carefree slideout topper how tochange the tension on a carefree of colorado.
During regular use of your rv the awning fabric and slide in the awning tube causing alignment is.
Different rv makers use different awning systems.
Roll the awning back up to observe how tight it is.
And i ve called and left a message still awaiting the return.
It s best to have three people for this job.
Step 5 re install awning.
You do not need to put the screws back in.
If not then repeat the previous steps.
Roll up topper on roller.
Run slide in about 12.
Put a cotter pin in the hole.
Depending on the make and model there is a different method to adjust the tension.
And rvs with slide outs a compartment that extends out from the main cabin providing extra living quarters are sometimes made with awnings over the slide out.
The awning over the big living room slide collects water because there is not enough tension to keep a constant slope.
Look for the pin hole near end of roller.
Remove end cap or mount.
Thanks for submitting your question on our ask an rv question page.
Two people will handle the awning arms one at each end while another one will feed the cord into your awning rail.
If you over tighten the spring it will break.
If you are satisfied move on.
The slight slack allows water to puddle then as the puddle gets bigger.
