How To Rig A Safety Line Working On A Roof

Installing a roof safety line.

How to rig a safety line working on a roof.

For about the same cost as a climbing rope you could get a full roofers kit that comes with a. After weeks of research we ve put together this roofing safety guide including roof safety equipment recommendations to help you choose the right products. The most desirable working area can be created when combining fully sarked roof areas with the use of safety mesh manufactured and installed to as nzs 4389. Safety first and always.

Ways to work on a steeply pitched roof. Since i am a very small contractor with limited scaffold equipment equipment and one partner we need some ideas in this area. 5 point safety harness. Due to the fact that i have solar panels and a wind turbine generator on my roof i wanted a means of securing myself via a body harness.

Additionally matching the ladder angle to the roof line works on some houses and areas and are useless due to accessibility issues on other areas. It should be noted that if traditional netting is used instead of safety mesh that meets as nzs 4389. Lifeline systems can be used to arrest workers in the event of a fall active system or restrain workers from reaching a fall hazard restraint. When on a roof you need to wear a harness connected to a securely anchored safety rope.

Read on for how i did this task. If you re going to buy a rope for a very specific job then you should get the right equipment for the job. Not every situation is suitable for guardrail in circumstance where a fall cannot be prevented fall protection lifeline systems are your next line of fall protection. Always face ladder and keep 3 points of contact with it both feet and a hand on stile and don t overreach.

Safety mesh then a total restraint system or fall arrest system shall be used until the roof coverings are in place. That way setup is quick and i can access both sides of the roof. The possibility of slipping and falling makes working on any roof dangerous but it s especially so if the roof rises more than 4 feet for every 12 feet of. Mike lane wrote if this is a work operation you ll need to comply to osha standards for fall protection.

Hahaha for roof shoveling i usually run a rope from trees on either side of the house perpendicular to the ridge and leave about 10 ft of slack in it.