I cut the tape so that it laps onto the housewrap above and 3 in.
How to flash a roof against a wall.
How to install roof flashing against a wall with a corner lay the underlaymentand the shingles fully up till the wall.
Once the flexible flashing is set i apply a piece of housewrap along the wall where the fascia meets it.
Layer the cement on the area that you.
Installing the roofing felt.
Place the first step flashing strip over the end of the starter course shingle and use two nails to fasten the step flashing to the roof with 2 nails.
It is commonly used in two story and side split houses.
Installing step flashing to stucco walls step 1.
Flexible flashing tape seals the eave to the wall.
The first step flashing or the corner flashing should rest.
Continuous flashing against a sidewall is one way to install a roof but it s not the correct way.
A 5 inch wide flashing will result in a 2 1 2 roof deck flange and 2 1 2 vertical wall flange.
Above the roof sheathing.
Next you will use asphalt or roofing cement.
For step flashing with a stucco wall you will be working in part on the roof.
How to install roof flashing against a wall.
I use a wide piece of flexible flashing tape to protect the area between the subfascia and the wall.
Metal roof flashing can be use to seal gaps between roof walls.
Next cut from the other corner on the same side of the step flashing and along 45 degrees to the centerfold.
Metal roof flashing is a galvanized sheet metal bent at right angles with about eight to 12 inches on each side of the angle.
Obviously the further up the wall a flashing extends the greater the resistance to water intrusion.
In this video isaac illustrates installation of an 18 w.
Do not fasten the flashing to the wall because it must float with the roof.
Add cement and flashing.
Step flashing redirects the water back onto the shingle.
Iws is used in conjunction with step flashing or 4x5 wall flashing to create a water tight junction.
